The following instructions can be used for installing the DJI Zenmuse X3 and XT cameras onto the rear of the Omni UAV.


NOTE: The camera should be installed on the aircraft before power is applied to avoid faulty gimbal calibration.


1. Locate the locking mount found on the rear of the vehicle.


2. Rotate the locking mount into the indicated "unlocked" position.


3. Align the top of the camera into the locking mount.


4. Twist the locking mount into the locked position.


Below are a few images of an unlocked locking mount and a fully installed Zenmuse XT camera.


Next - DJI Hand Controller Setup

Previous - Propeller Installation