Single

Changing the Overlap on the Single Sensor
You can change the overlap of the Single by following the steps below. 1.) Remove the MicroSD Card from your Sentera Sensor and insert it into your PC....
Wed, 3 Oct, 2018 at 1:43 PM
Single Sensor LED Codes (For Model # 21011-00 and up)
The Sentera Single has 3 LEDs that indicate the status of the camera. LED Status Description Details GREEN ON Power Good Camera is powered. GREEN ...
Fri, 19 Jan, 2018 at 11:15 AM
Single Sensor Technical Documentation & Integration Guide
Here are some helpful documents describing the details of the Sentera Single. Sentera Single Hardware Intergration Guide (.pdf) Sentera Single Cad Model ...
Wed, 2 May, 2018 at 1:57 PM
Upgrading Firmware on Your Single Sensor
To upgrade the firmware on your Single, follow these steps. 1. Remove the SD card from the Single and put it into a computer running FieldAgent™. 2....
Thu, 18 Jan, 2018 at 8:26 AM
Light Sensor Installation Manual
Detailed Incident Light Sensor Installation instructions for End User Install.
Fri, 19 Jan, 2018 at 11:17 AM
GSD for Sentera Single NIR Sensor as of 07-05-2017
1.2 MP  11.0cm @ 400ft 8.3cm @ 300ft 5.5cm @ 200ft
Fri, 19 Jan, 2018 at 11:17 AM
Time Based Triggering for Sentera Single Sensor
For a number of users, the ability to have the Sentera Single Sensor trigger based on the interval of seconds vs. overlap has been helpful on a small test o...
Fri, 19 Jan, 2018 at 11:18 AM
Single Sensor Gimbal for Phantom 4
The Single Sensor Gimbal for Phantom 4 adds the ability to compensate for drone pitch and roll caused by vehicle dynamics or wind, resulting in photos th...
Wed, 4 Apr, 2018 at 4:51 PM