Vehicle Case - Overview
The vehicle case contains the Omni UAV and minimum items necessary for flight.  Make sure the logo is facing up when opening the case.  There are 6 latch...
Fri, 19 Jan, 2018 at 4:48 PM
Ground Control Station - Overview
The purpose of the Ground Control Station(GCS) is to serve as ground side communications to the aircraft. When assembled, the Comms Box broadcasts a Wi-Fi n...
Fri, 19 Jan, 2018 at 4:49 PM
Charging - DJI Batteries and Hand Controller
Refer to the image below for the charging setup of the Omni Batteries and DJI Hand Controller. Components: Charging Cable and included AC/DC convert...
Fri, 19 Jan, 2018 at 4:52 PM
Installing Batteries and Powering the Vehicle
There are two battery compartments located on the Omni vehicle; one on top and one on the bottom. To install a battery, ensure the battery is off, and then ...
Fri, 19 Jan, 2018 at 4:54 PM
GPS Mast
The GPS mast can be flipped up and down. When installing and uninstalling a battery in the top compartment, it is helpful if the GPS is in the down position...
Fri, 19 Jan, 2018 at 4:55 PM
Propeller Installation
There are 3 sets of propellers included in the propeller compartment of the main case. Each set consists of 1 Clockwise and 1 Counter-Clockwise propeller. T...
Fri, 19 Jan, 2018 at 4:56 PM
DJI Hand Controller Setup
Next - GCS Setup Previous - Propeller Installation
Fri, 19 Jan, 2018 at 4:57 PM
GCS Setup
Charging the Battery Do not confuse the thin, Anker, USB cable with the thicker Gimbal Controller USB cable, as the cable labeled “Anker” is intended to ch...
Fri, 19 Jan, 2018 at 4:59 PM
GCS Placement and Status
Next - Charging the Gimbal Hand Controller Previous - GCS Setup
Fri, 19 Jan, 2018 at 5:00 PM
Charging the Double 4K Gimbal Hand Controller
The gimbal hand controller, supplied in the GCS Case, is powered with an included micro USB cable. Original packaging will have the USB cable located in the...
Fri, 19 Jan, 2018 at 5:00 PM